Utility sink faucets are different than faucets you find on kitchen and bathroom sinks, and you attach and remove them the way. Replacing a utility sink faucet can be easier, in reality, because the sink is more often freestanding, with space to work supporting it. The faucet is stored on by nuts that you simply loosen with even a basin wrench or pliers. It must be the exact same dimensions, although the faucet does not have to be the exact same type as the one which you remove.

Turn off the shutoff valves under the sink to prevent water flow into the faucet. Unscrew the hoses out of the stops using adjustable pliers. Use the pliers to unscrew the hoses.

Unscrew one end from the waste line of the P-trap from the drain tailpiece and the end. Eliminate to give your room to operate. Remove the screws holding it into the wall and the ground using a screwdriver if the sink is moveable and pull it away from the wall.

Locate the nuts stalks into the sink. You’ll have to crawl beneath it to do this, if the sink can’t move. Bring a flashlight so you can see what you’re doing.

Unscrew the nuts using a socket wrench or pliers. As soon as they’re loose, then you can frequently back them all the way off with your palms. Lift the faucet, after you have removed the nuts.

Clean using water and soap and a scrub brush off the region round the faucet. Remove by pulling it off with your fingers or cutting off it .

Unpack the faucet and remove the base plate which is included with it. Fit the inlet stalks through the holes in the bottom plate and then fit the plate on the base of the housing that is faucet. Some faucets have a single stem in the center and a plate using a hole that is fitting. It’s nice to use this type of faucet onto a utility sink, as long as there’s a hole for it. If needed, one can be drilled by you into a plastic spout using a bit.

Insert the faucet inlets and then twist the nuts on the threaded rods. Tighten the nuts as far as you can by hand. Then the continue tightening them with pliers or a socket wrench and faucet. Check the faucet to ensure it didn’t move, when the nuts are tight.

Screw a flexible supply hose into one and the cold water inlet into the warm having pliers. You are going to want new flexible hoses if the inlets on the faucet are a different size than those around the old one, but you can probably reuse the hoses, since faucets have MPT inlets.

Move the sink into position and reattach it into the ground and the wall. Screw the hoses and then reconnect with the P-trap. Open the faucet, turn on the hot and cold valves and flush the faucet to remove debris and air. Turn off the faucet when the water runs clear.

See related