It could be completed with urushiol if you have an old and precious black oriental side table. That’s a very long shot it’s more likely that your table has been sprayed with nitrocellulose lacquer. This finish is durable, particularly when exposed to sunlight, but discolor and it finally starts to crack. If you refinish nitrocellulose lacquer, it is necessary or advisable to strip the old finish. The finish wills melt and amalgamate to it ; if you correctly prepare the finish, you will have a fantastic foundation to get a fresh one.

Stripping the Old End

Run a scraper gently across the surface of the desk to see whether any of those finish flakes off. If it does, it’s ideal to strip the table because the voids left from the finish that is flaking create height differences.

Strip the table — if needed — with a citrus-based stripper. This type of stripper is safer and less hazardous than methylene chloride products; they function nicely to remove.

Wipe the table down with a rag. If any lacquer still remains on the timber, wipe it off with lacquer thinner.

Sand the wood by hand with 120-grit sandpaper. It’s best not to use a sanding machine, since it can change the form of the edges of the tabletop and thighs. For sealing, sand again to prepare the table. Wipe off the sanding dust with a damp rag.

Preparing an Old End

Wash the table if the aged finish is stained and cracked, but it isn’t peeling. Mix of dish detergent with a gallon of warm water, and wash the table.

Scuff-sand the finish with 220-grit wet/dry sandpaper. Go the entire table with paper that is dry over, and then soak the paper and utilize the paper to level dents or large cracks.

Wipe all of the dust and residue off with a rag, and also let the table dry.

Implementing the End

Transfer the table. If you’re like 99.99% of individuals, and you don’t have a spray space, create a spraying place in a utility room, garage or cellar. The room should have tons of light and a window which you can open.

Mask that you don’t wish to spray, using painter’s tape. Remove this with a screwdriver, if the table has metal hardware and put it in a place that is safe.

Spray the lacquer using equipment, or use cans. If you stripped your desk, begin by applying a coat of clear lacquer sanding sealer. Anyone in the room while you’re spraying — including you — should put on a respirator.

Allow the sanding sealer dry — that takes under an hour — and scuff-sand the table with sandpaper.

Fill the cup of your spray gun on two-thirds full of lacquer or utilize an aerosol can of lacquer. A single coat across the entire table; a wet coat is slim, but it’s glossy. Allow the lacquer dry for an hour.

Scuff the lacquer coat and spray on another coat. Repeat this process as many times as necessary to create a smooth surface. If you’re painting over an old finish, you might need only two or three coats, however if you’re starting from scratch, you might need five or six.

See related